About Custom Mapping:

Having a custom map built for your fuel-injected motorcycle is the only way to optimize the bikes' performance. Adding upgrades to your bike such as performance exhaust or high-flow air filters will not give your bike more power without a re-map. Most often, the bike will have less power than it did stock! The reason is the performane upgrades do exactly what they should- get more air into the engine. But, the computer is still only supplying the pre-programmed amount of fuel so the bike runs lean and looses HP. The dyno session allows us to correct the fuel curve for a perfect air/fuel ratio at every throttle position and rpm. We can (and have) map any fuel-injected bike with a Power Commander- V-Twins, sportbikes, drag racers, road course racers, nitrous bikes, and turbo bikes.

Dyno Rates:

Custom Map on any Fuel Injected Bike: ............$250
100% Throttle Map Only: ....................................$100
Nitrous Map .........................................................$125
HP, Torque, Air/Fuel Pull.....................................$50

Dyno Rental: $150 for the 1st hour, $75 each additional hour. 2 hour minimum.


Pre Dyno Notes:

Make sure your bike is ready for the dyno session. The bike should have a full tank of the fuel you will be running. Different fuels require different maps so be sure we don't build your map on a fuel you won't be using. It is your responsibility to make sure bike has oil, the chain is lubed, clutch plates are fresh, and the rear tire is in good condition with the proper psi. Also, remove the front fairings on the bike prior to arriving for your session. This allows good access for the dyno fans to the radiator.

FAQ's

Is a dyno session stressful or harmful to my engine?
No, even though a custom map may take 1 1/2 to 2 hours to build, the majority of the time is spent below half-throttle where the bike isn't turning max rpm.

Can you map my bike without a Power Commander?
No, we only map fuel-injected bikes using Power Commanders.

Can you tune my carbureted bike?
Yes, we run the dyno but it is up to the customer to supply the jets, installation, and tools. Carbureted bikes fall under the dyno-rental rates.